Attaching the MSR/keypad
Follow these steps to attach the MSR/keypad to the 4820 SurePoint Solution:
1. Remove the MSR/keypad connector cover from the rear of the 4820 by pulling
upward on the cover. Discard this connector cover.
2. Attach the keyboard to the display.
v Models 2xx and 5xx: Align the MSR/keypad (1 in Figure 44) so that the
connectors are slightly above their matching slots on the 4820. Slide the
MSR/keypad downward (2) until it snaps into place.
v All other models: Align the MSR/keypad with the edge (1) of the 4820 so
that the top edge of the 4820 aligns with the top of the keypad. Slide the
keypad unit downward (2) until it snaps into place.
3. Attach the keypad cable to the MSR/keypad connector.
S1
S2
1
2
Figure 44. 4820 SurePoint Solution with attached keypad/MSR
Installing options
Update November 2005
Chapter 2. Installing the IBM 4820 45
|
|
|
|
|
|
|
To Next Page
Loading...
Need help?
General
