How
to
Insert Forms
Continuous Forms
Form Guide Rack
Paper-Advance Knob
Vernier Knob
Forms Path for Singlepart Forms
__
~f
/Forms
Guide Rack \
~::=====-====--.>\(jn
lower
positiont
Forms Path for Multipart Forms
Friction Feed Rolls
170
1.
Pivot the plastic shield forward.
2.
Push the print head
to
the extreme left position.
3.
For singlepart forms, pivot
the
form guide rack
up and forward
to
a vertical position. For multi-
part forms, leave the forms
gUide
rack
in
the
horizontal position.
The diagrams below and
to
the
left show
the
proper
forms path for singlepart and multipart forms.
4. Push the paper release lever
to
the
rear
to
acti-
vate
the
friction feed rolls.
5.
Place
the
forms on
the
table behind
the
printer.
Note: The forms must be positioned behind
the
printer so
that
the forms feed squarely into the printer.
6. Thread
the
paper down, over
the
rollers, behind
the
tractors, and behind
the
platen.
7.
Turn
the
paper-advance knob
to
move
the
paper around
the
platen until you can grasp it with your fingers.
Position these guides
at
the
edge
of
the paper.
\
"..
To Next Page
Loading...
Need help?
General