Code Function Result Text message Action
264 Magnetic tape
drive
Aborted Test setup error: No tape drive found Check the cable and
power connections to
the drive.
Refer to the information
provided with the tape
drive.
If the problem persists,
call for service.
Failed The load/mount test failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
Refer to the information
provided with the tape
drive.
If the problem persists,
call for service.
Note: The push button
test is applicable only to
SCSI tape drives that
have a push button.
The self-diagnostic failed for device n on adapter
m.
(where n is the number of the device and m is the
adapter number)
The unload/eject test failed for device non adapter
m
(where n is the number of the device and m is the
adapter number)
The unload/eject push button test failed for
device n on adapter m
(where n is the number of the device and m is the
adapter number)
The Read/Write Self-diagnostic failed for device n
on adapter m
(where n is the number of the device and m is the
adapter number)
Insert a new tape
cartridge; then, run the
diagnostic test again.
Refer to the information
that is provided with
the tape drive.
If the problem persists,
call for service.
301 Keyboard Failed On system-board keyboard test failed
1. Verify that the
keyboard cable is
connected.
2. If the problem
remains, replace the
keyboard cable.
If the problem persists,
call for service.
302 Mouse Failed On system-board pointing device test failed. Replace the pointing
device. If the problem
persists, call for service.
305 Video monitor Any message Refer to the information
that came with the
monitor.
Chapter 6. Solving problems 57
To Next Page
Loading...
Need help?
General
