IBM iSeries 820 Hardware Problem Analysis And Isolation

SIRGCFG
For use by authorized service providers.
An invalid configuration was detected on an HSL loop during IPL.
The four rightmost characters of word 4 in the SRC contains a Program Return Code (PRC) which
describes the problem detected. The leftmost four digits of word 7 in the SRC contains the loop number in
hexadecimal format. Convert the loop number to decimal format before comparing it to loop numbers
shown in HSM.
To determine the problem, find the PRC in the table below.
Note: The FRU description in the SAL may already contain a message that identifies the problem.
PRC (in word 4 of
the SRC)
Problem identified Corrective action
xxxx 0008 System serial number not set Set the serial number on the system unit.
See the iSeries
(TM)
Service Functions
.
If the problem persists contact your next level
of support.
xxxx 3200 Clustered system(s) on loop with SPD
migrated tower
For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: Remove clustered systems from the
loop with the migration tower.
xxxx 3201 Clustered systems on multiple HSL loops Ensure all clustered systems are on the
same HSL loop.
xxxx 3202 Multiple SPD migrated towers detected For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: Only one migration tower is supported
on a system. Remove the additional
migration towers.
xxxx 3207 SPD migrated tower not on first HSL loop For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: Move the migration tower to the first
HSL loop. The first HSL loop is number 256
and attaches to ports A0 and A1 on the
network interface controller (NIC) card of the
system unit. The first HSL loop connects to
the system frame at HSL ports A0 and A1.
xxxx 3212 NIC level does not support opticonnect For Models 800, 810, 825, 870, and 890
only: Migration towers are not supported on
these models. Remove them.
For Models 270, 820, 830, 840, SB2, and
SB3: See Corrective action for xxxx 3212
(See page 457) below.
456 iSeries: iSeries Server 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Hardware Problem Analysis and
Isolation

IBM iSeries 820 Specifications

General

Brand	IBM
Model	iSeries 820
Category	Server
Language	English