8. Grasp the release handles located on top of the processor assembly. Pivot the
handle upward to 90 degrees. This action puts the handle cams into the correct
position to help seat the processor card connector into the docking connector
located on the CEC backplane.
Attention: To prevent damage to the processor card assembly and the processor
card connector, open or close both release handles at the same time.
9. Align the processor card connector with the docking connector located on the CEC
backplane.
10. Carefully insert the processor card assembly into the system.
11. As the processor connector is seated into its CEC backplane docking connector,
begin lowering the processor assembly release handles. This action correctly seats
and locks the processor assembly to the CEC backplane.
12. If necessary, replace the processor protective filler panel.
13. Replace the media support shelf. Tighten the thumbscrew located on the support
shelf.
Note: When replacing the support shelf, ensure that the lower support leg
activates the microswitch located on the CEC backplane. Failure to do so
results in the system not being able to power on.
14. Replace all removed media drives, ensuring that the media drives removed are
returned to the same media bay locations from which they were removed. Refer to
“Media Drive Replacement” on page 103.
15. Reconnect all power and signal cables to their respective media drives.
16. Replace the front bezel as described in “Front Bezel Replacement (Model 6C4)” on
page 62 or “Front Bezel Replacement (Model 6E4)” on page 63.
17. Replace the service access cover as described in “Service Access Cover
Replacement (Model 6C4)” on page 55 or “Service Access Cover Replacement
(Model 6E4)” on page 58.
18. On a Model 6C4, push the system drawer back into the operating position as
described in “Returning the Model 6C4 to the Operating Position” on page 54.
19. Power on the system as described in “Starting the System” on page 52.
20. If the Model 6C4 has successfully powered on, close the rack doors.
If the Model 6E4 has successfully powered on, close the bezel door.
118 Eserver
pSeries 630 Model 6C4 and Model 6E4 Installation Guide
To Next Page
Loading...
Need help?
General