Bezel Door (Model 6E4)
The following procedure covers removal and replacement of the bezel door.
Bezel Door Removal (Model 6E4)
To remove the bezel door, do the following:
1. Open the bezel door by grasping the bezel door handle. Pull the bezel door out,
and away from the system.
2. Press down on the top back edge of the door.
3. Gently swivel the top back edge of the door forward, out past the top of the system.
4. Lift the door up to release it from the bottom post.
1 Model 6E4 5 Bezel Door Handle
2 System Handle Assembly 6 Bezel Door Lock Tab
3 Bezel Door Top Retaining
Post
7 Bezel Door Lower Retaining Post
4 Bezel Door
Bezel Door Replacement (Model 6E4)
To replace the bezel door, do the following:
1. Set the bezel door on the lower post. See the above illustration.
2. Rotate the bezel door toward the top of the system.
3. Press down on the back edge of the bezel door and seat the top post in the
matching hole.
Note: The matching hole for the top post is located on the bottom side of the
system handle assembly.
4. Close the bezel door.
60 Eserver
pSeries 630 Model 6C4 and Model 6E4 Installation Guide
To Next Page
Loading...
Need help?
General