Step 2. Need Help?
If you encounter difficulties while setting up your system unit, contact your sales
representative for assistance.
Step 3. Read the Safety Notices
Before continuing, read the following safety information. Do not plug any cables into the
system, adapters, or electrical outlets until you have reviewed this information. Make
sure none of the power cables are connected before continuing to the next step.
In the system you are about to set up:
v The ac power-interface connector is considered the main power disconnect device.
v This system has redundant power supply capabilities, in that it has the ability to have
two power supplies running simultaneously in the same system unit. When instructed
to disconnect the power source, ensure that all power cables have been unplugged.
DANGER
An electrical outlet that is not correctly wired could place hazardous voltage
on metal parts of the system or the devices that attach to the system. It is the
responsibility of the customer to ensure that the outlet is correctly wired and
grounded to prevent an electrical shock.
Before installing or removing signal cables, ensure that the power cables for
the system unit and all attached devices are unplugged.
When adding or removing any additional devices to or from the system,
ensure that the power cables for those devices are unplugged before the
signal cables are connected. If possible, disconnect all power cables from the
existing system before you add a device.
Use one hand, when possible, to connect or disconnect signal cables to
prevent a possible shock from touching two surfaces with different electrical
potentials.
During an electrical storm, do not connect cables for display stations, printers,
telephones, or station protectors for communications lines.
10 Eserver
pSeries 630 Model 6C4 and Model 6E4 Installation Guide
To Next Page
Loading...
Need help?
General