Step 8: Install the Cable Management Arm
To install the Model 6C4 cable management arm, do the following:
1. Attach the cable carrier support bracket to the back of the chassis with two screws.
2. Place the two captive snap buttons, located on the cable management arm, into the
unlocked (pulled out) position.
3. Align and insert the two captive snap buttons into the holes located on the cable
carrier support bracket. Pushing in on the head of the snap buttons locks them into
position.
1 Model 6C4 4 Rack Flange Mounting Bracket
2 Cable Carrier Support Bracket 5 Cable Management Arm
3 Captive Snap Button (Qty. 2)
4. Open the cable management arm so that the hinged mounting plate lies flat against
the flange-mounting bracket.
5. Align the holes, located on the cable management arm mounting plate, with the
threaded holes on the rack-flange mounting bracket. Secure the bracket with two
screws.
Note: To avoid any binding of the cable management arm, ensure that the cable
management arm is level.
24 Eserver
pSeries 630 Model 6C4 and Model 6E4 Installation Guide
To Next Page
Loading...
Need help?
General