EasyManuals Logo
Home>IBM>Touch terminals>SurePOS 700 Series

IBM SurePOS 700 Series User Manual

IBM SurePOS 700 Series
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
DRAFT
Chapter 2. Installing Windows 2000
This section describes the installation steps for Windows 2000 using either the
network or a CD-ROM
Hardware and software requirements
This installation requires a SurePOS 722/742/782 or SurePOS 723/743/783 with a
minimum configuration as follows:
v 128 MB read access memory (RAM)
v 40 GB minimum hard disk drive
v USB or PS/2 keyboard
v Internal CD-ROM or external USB CD-ROM drive
v External USB floppy disk drive for certain installation configurations
v Windows 2000 installation CD or LAN server with required installation files (for
network installation)
v Intel
®
AHCI/RAID diskette if installing on Models 742, 782, 723, 743, and 783
with AHCI (Advanced Host Controller Interface) or RAID enabled (diskette image
available from the IBM Retail Store Solutions Web site at http://www.ibm.com/
solutions/retail/store/support)
v Windows 2000 Professional CD
v DOS Network/CD-ROM boot disk
v Partitioned and formatted hard disk. See “Partitioning the hard disk” on page 2.
CD-ROM preinstallation steps
Follow these steps before you begin:
1. Boot the system with the DOS Network/CD-ROM Boot Disk.
Important
Steps 2 and 3 below are not required; however, they aid in field support
because operating system components can be added and removed in the
field without the need of a CD-ROM drive.
As a performance tip, using the SmartDrive DOS utility prior to the
installation of Windows 2000 Professional will greatly reduce the amount of
time spent copying files. The syntax is smartdrv c+.
2. To create a directory on the hard disk which will store the Windows 2000
Professional installation files, type mkdir c:\wininst from a command prompt.
3. To copy the Windows 2000 Professional Installation files from the CD-ROM to
the hard disk, type copy x:\i386\*.* c:\wininst from a command prompt.
Note:
The Windows 2000 Professional installation files can be found in the i386
directory of the CD-ROM. These are the only files on the CD that are
required for installation.
4. Continue with “CD-ROM installation steps” on page 6.
Updated October, 2007
© Copyright IBM Corp. 2007 5

Table of Contents

Other manuals for IBM SurePOS 700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM SurePOS 700 Series and is the answer not in the manual?

IBM SurePOS 700 Series Specifications

General IconGeneral
BrandIBM
ModelSurePOS 700 Series
CategoryTouch terminals
LanguageEnglish

Related product manuals