To Next Page

To Previous Page

DRAFT

3. Power off the machine.

4. Continue with the steps described in “Replacing and rebuilding a hard drive.”

Replacing and rebuilding a hard drive

Note: Before beginning these procedures, you should have completed one of the

two methods on determining the failed hard disk drive.

1. To open the machine, follow Steps 1 through 3 in the "Removing the hard disk

drive" section in the IBM SurePOS 700 Series - SurePOS 700-721/741/781,

722/742/782 Hardware Service Guide or in the IBM SurePOS 700 Series -

SurePOS 700-723/743/783 Hardware Service Guide.

2. Trace the serial ATA (SATA) cables from the hard disk drives to the system

board.

Note:

Drive 0 connects to SATA connector 0 and Drive 1 connects to SATA

connector 1.

3. Continue with the instructions in "Removing the hard disk drive" to remove and

replace the failing hard disk drive.

4. Reassemble the machine and power on.

Figure 3. Boot up warning

Updated October, 2007

Chapter 5. Using the RAID application 23

Other manuals for IBM SurePOS 700 Series

Questions and Answers:

Need help?

Do you have a question about the IBM SurePOS 700 Series and is the answer not in the manual?

General