IBM SurePOS 700 Series User Manual

DRAFT
Chapter 5. Using the RAID application
Note: This section requires procedures described in these publications:
v IBM SurePOS 700 Series - SurePOS 700-721/741/781, 722/742/782
Hardware Service Guide
v IBM SurePOS 700 Series - SurePOS 700-723/743/783 Hardware Service
Guide
The
Redundant Array of Inexpensive Disks (RAID) application supports Models 742,
782, 723, 743, and 783 with one or two hard disk drives and the Microsoft Windows
operating system. RAID provides an error message should one of the two hard disk
drives experience a failure (see Figure 1).
Determining a hard drive failure
When the RAID program indicates a hard drive failure, you can determine which
drive has failed using one of the following two methods:
Method one: Clicking on the RAID icon
1. From the Microsoft Windows task bar, click on the RAID icon. This icon only is
present during an array rebuilding or if abnormal activity occurred, such as a
failed drive. The Intel Storage Utility opens.
Figure 1. RAID hard drive failure dialog box
Updated October, 2007
© Copyright IBM Corp. 2007 21

IBM SurePOS 700 Series Specifications

General

Brand	IBM
Model	SurePOS 700 Series
Category	Touch terminals
Language	English