IBM SurePOS 700 Series User Manual

DRAFT
Network installation
Numerous options are available when installing networking on the IBM SurePOS
700. The most common method is using a DOS network redirector. This section
describes how to install Microsoft
®
LAN Manager 2.2c with TCP/IP.
Installing Microsoft LAN Manager 2.2c
Prerequisites
v SurePOS 700 with PC DOS 2000 installed
v Microsoft LAN Manager 2.2c diskettes
v SurePOS 700 DOS Ethernet driver diskette
Installation steps
1. Boot PC DOS 2000.
2. After the command prompt appears, insert disk 1 of 4 of the Microsoft LAN
Manager 2.2c diskette set.
3. At the command prompt, type a:\setup.exe and then press Enter.
4. Press Enter after the first Microsoft LAN Manager Setup prompt appears.
5. Press Enter after the Using the Keyboard in Setup prompt appears.
6. Accept the default directory and press Enter.
7. Choose LAN Manager Enhanced and press Enter.
8. Insert the DOS DRIVERS 1 diskette (Disk 2 of 4) and press Enter.
9. At the Network Adapter Drivers screen, press Alt to install a custom driver.
10. Insert the SurePOS 700 DOS Ethernet driver diskette.
11. Choose the Intel 82593 Motherboard LAN Module from the list and press
Enter.
12. Select MS TCP/IP, press the Spacebar and press Enter.
13. Press Enter to accept defaults and then press Enter again.
14. The TCP/IP Settings page lets you configure the IP address. If you can use
DHCP, press Enter to continue; otherwise, configure the IP address and/or
WINS server and press Enter.
15. Set the computer name and domain name on the Workstation Settings page.
See the network administrator for assistance with these settings. Press Enter
when finished.
16. The Support for the Windows Environment page appears. Choose No and
press Enter.
17. The Memory Management page appears. Choose Yes to maximize the amount
of memory in the system available to programs.
18. The Configuration Complete page appears. Press Enter to save the changes
made during this session.
19. Insert the DOS DRIVERS 2 diskette (Disk 3 of 4) and press Enter.
20. After file copying has completed, press Enter to exit setup.
21. Configure the networking environment to support the SurePOS 700 Ethernet
adapter. Follow these directions very carefully to ensure a smooth installation:
a. From a command prompt, type: copy a:\dos\e100b.dos
c:\lanman.dos\drivers\ethernet\mlm and press Enter.
b. From a command prompt, type e config.sys and press Enter. Change all
occurrences of I82539 to e100b.
Updated October, 2007
18 SurePOS 700 Series: SurePOS 700-722/742/782, 723/743/783 Operating System Installation Guide

IBM SurePOS 700 Series Specifications

General

Brand	IBM
Model	SurePOS 700 Series
Category	Touch terminals
Language	English