IBM System x3650 M4 Type 7915 User Manual

SAS signal cables
Power
cable
Configuration
cable
eXFlash 1.8-inch drive cage
and backplane assembly
8. Touch the static-protective package that contains the RAID adapter to any
unpainted metal surface on the server. Then, remove the RAID adapter from
the package.
9. Remove the PCI riser-card assembly 1 (see “Removing a PCI riser-card
assembly” on page 55).
10. Install both RAID adapters in the connectors on the PCI riser card (see
“Installing a PCI adapter” on page 60).
Attention: Incomplete insertion might cause damage to the server or the
adapter.
11. Connect the SAS signal cables to the connectors on the RAID adapter:
a. Connect a SAS signal cable that comes with the option kit to the RAID
adapter connector for drive bays 8-11.
b. Connect another SAS signal cable to the other SAS connector for drive
bays 12-15.
86 System x3650 M4 Type 7915: Installation and User’s Guide

IBM System x3650 M4 Type 7915 Specifications

General

Form Factor	2U Rack
Chipset	Intel C600 series chipset
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware vSphere
Processor	Up to two Intel Xeon E5-2600 series processors
Memory	Up to 768GB DDR3 (24 DIMM slots)
Storage	Up to 16 x 2.5" or 6 x 3.5" SAS/SATA HDDs or SSDs
RAID Support	RAID 0, 1, 10
Network	Four integrated Gigabit Ethernet ports
Power Supply	Up to two redundant hot-swap 550 W, 750 W, or 900 W power supplies
Expansion Slots	Up to 7 PCIe 3.0 slots
Storage Controller	ServeRAID M5110e
Management	Integrated Management Module (IMM) v2