Select this choice to prevent the server from booting the operating
system and displaying the POST event viewer when a severe error is
detected during POST.
– Storage
Select this choice to view and manage RAID controller configurations.
– Network
Select this choice to view or configure the network device options, such as
iSCSI, PXE, and network devices. There might be additional configuration
choices for optional network devices that are compliant with UEFI 2.1 and
later.
– Driver Health
Select this choice to view the health of the controllers in the server as
reported by their device drivers.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Select this choice to view the startup sequence or select an option to try and
boot from immediately. Changes in the startup options take effect when you
start the server.
v Boot Manager
Select this choice to view, add, delete, or change the device boot order, boot from
a file, boot from a device, or boot the UEFI shell. This choice is on the full Setup
utility menu only.
v System Event Logs
Select this choice to enter the System Event Manager, where you can view the
POST event log and the system-event log. You can use the arrow keys to move
between pages in the error log. This choice is on the full Setup utility menu only.
The POST event log contains the most recent error codes and messages that
were generated during POST.
The system-event log contains POST and system management interrupt (SMI)
events and all events that are generated by the baseboard management
controller that is embedded in the integrated management module (IMM).
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the system-event log. Also, after you complete a
repair or correct an error, clear the system-event log to turn off the system-error
LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the error messages
in the POST event log.
– System Event Log
Select this choice to view the system-event log.
– Clear System Event Log
Select this choice to clear the system-event log.
v User Security
Select this choice to set, change, or clear passwords. The full Setup utility menu,
enables all of the options in the User Security option. See “Passwords” on page
132 for more information.
Chapter 3. Configuration information and instructions 131
To Next Page
Loading...
Need help?
General