12. Reinstall the 10 Gb Ethernet adapter, if you removed it earlier (see “Replacing
the IBM Dual port 10Gb-T (copper) Ethernet Adapter or the IBM Dual port
10Gb SFP+ (fibre) Ethernet Adapter” on page 273).
13. Reinstall the power interposer card assembly, if you removed it earlier (see
“Replacing a power interposer redundant power supply card assembly” on
page 290).
14. Reconnect the cables that you disconnected earlier to the system board.
15. Reconnect the remote RAID battery cables and flash power module cables to
the adapters and install the RAID batteries in the trays located on the top of
the front USB/video assembly, if you removed them earlier.
16. Reinstall DIMM air baffle, if one was installed (see “Replacing the DIMM air
baffle” on page 233).
17. Reinstall the microprocessor and memory expansion tray, if one was installed
(see “Replacing the microprocessor and memory expansion tray assembly” on
page 307).
18. Slide the power supplies back into the bays until they click into place.
19. Reinstall the backplanes and cables, if you removed them.
20. Reinstall the fan cage assembly (see “Replacing the fan cage assembly” on
page 271).
21. Reinstall the cover (see “Replacing the server top cover” on page 227).
22. Slide the server into the rack.
23. Reconnect the power cords and any cables that you removed.
24. Turn on the peripheral devices and the server.
Results
Important: Perform the following updates:
v Either update the server with the latest RAID firmware or restore the
pre-existing firmware from a CD or DVD image.
v Update the UUID and the DMI/SMBIOS (see“Updating the Universal Unique
Identifier and DMI/SMBIOS data” on page 158 ).
Internal cable routing
This information describes how to route cables in the server.
This section provides information about routing the cables when you install some
components in the server.
For more information about the requirements for cables and connecting devices,
see the documentation that comes with these devices.
Cabling the CD/DVD drive:
Chapter 6. Removing and replacing components 319
To Next Page
Need help?
General