18
5
SCAN OPERATION
■ Scanning preparation
IC-41S scans all tagged channels, and can be selected so
the scan resume condition is a pause or timer scan.
Therefore, these items must be set before starting a scan
(except the repeater search scan). These items must be set
for each scan type (open, group and priority) independently.
DScan type selection
➥ Push (Scan Mode) several times to select the desired
scan type.
• Open, group and priority scans are available.
• “OPEN”, “GROUP” or “PRIO” is displayed for 1 sec. when each
scan type is selected.
DTag channel setting
q Select the desired scan type. (See at left.)
w Select the desired channel. (p. 11)
e Push and hold
(Scan Tag) for 2 sec. to toggle the tag
channel setting ON and OFF.
• “S” appears when the tag setting is ON (The channel is set as a
scan channel).
To speed up scanning:
For open scan, cancel the tag channel setting to skip unde-
sired channels such as usually busy channels.
For group scan, set only often-used channels as tag chan-
nels.
All memory channels may be set as tag channels by
default.
To Next Page
Loading...
Need help?
General
