37
9
SET MODE
9
D Time-Out timer (TOT)
The Time-Out Timer (TOT) function limits continuous trans-
mission to prevent accidental prolonged transmission, etc.
This timer cuts a transmission OFF after 1 min. of continuous
transmission.
D Lockout function
Select the transmission lockout (temporary transmission
inhibit) capability.
RP
(Repeater Lockout) : Transmission is permitted only while
receiving a matched CTCSS tone, or
receiving no signal.
BU
(Busy Lockout)
: Transmission is inhibited while receiv-
ing a signal.
OF
(OFF) : No restriction for receiving a signal.
DScan resume timer
The scan resume condition can be set as a pause (P5) or
timer scan (15/10/5). When a signal disappears, scan
resumes after 5 sec. has passed regardless of the setting.
15/10/5 : Scan pauses for 15, 10 or 5 sec. when a signal is
detected, then resumes after that.
P5 : Scan pauses until the signal disappears and then
resumes after 5 sec.
DScan restart function
This function starts the scan after the transmission is per-
formed during scan and 10 sec. has passed.
To Next Page
Loading...
Need help?
General
