26
7
SELCALL OPERATION
r Push [PTT] to transmit to the selected TX code channel,
or push
(TX Code CH) to set the selected TX code
channel and return to the stand-by mode.
✔
CONVENIENT!
The TX code channel name can be assigned to the all 32 TX
code channel via the optional CS-41S
CLONING SOFTWARE
.
The TX code channel name allows you to easy to select the
channel, find the channel user, and so on.
DTX code number edit
(TX Code CH) enables you to change the TX code con-
tents within the allowable digits.
The group call function works by allowing you to edit a special
‘group code’ into the last 2 digits position of the SelCall ID
code.
To edit a TX code:
q Select the desired CB channel (‘CB-XX’) except for chan-
nels 5 and 35. (p. 11)
w Push [Top]
(Function) to enter the function mode, then push
(TX Code CH) to enter the TX code channel selection
mode.
• Push [CH Up] or [CH Down] to select the desired TX code
channel, if desired.
e Push and hold (TX Code CH) for 2 sec. again to enter
the TX code edit mode.
r Push (TX Code CH) to select the desired digit to be
edited.
To Next Page
Loading...
Need help?
General
