7
61
MEMORY OPERATION
2001 NEW
■ Memory channels
The transceiver has 101 memory channels (plus 1 call
channel). The memory mode is very useful for quickly
changing to often-used frequencies.
All 101 memory channels are tuneable which means
the programmed frequency can be tuned temporarily
with the tuning dial, etc. in memory mode.
■ Memory channel selection
DD
In VFO mode
q Push [V/M] to select VFO mode, if necessary, then
rotate [M-CH] to select a memory channel number.
•All memory channels including blank channels can be
selected.
•“BLANK” appears when no information has been pro-
grammed into a memory channel.
w Push [V/M] to select memory mode.
•“MEMO” and contents of the memory channel appear.
DD
In memory mode
q Push [V/M] to select memory mode.
w Rotate [M-CH] to select a memory channel.
•All memory channels including blank channels can be
selected.
•Memory channels can also be selected using the micro-
phone [UP]/[DN] keys.
Disappears when a channel is programmed.
• During VFO mode
• During memory mode
MEMORY
MEMORY
TRANSFER OVER-
CHANNEL
CHANNEL CAPABILITY
TO VFO WRITING
CLEAR
NUMBER
Regular memory
1–99
One frequency and one mode
Yes Yes Yes
channels in each memory channel.
Scan edge
One frequency and one mode in
memory P1, P2 each memory channel as scan Yes Yes No
channels edges for programmed scan.
Call channel C Same as regular. No Yes No
IC-7400.qxd 02.4.2 11:35 Page 61
To Next Page
Loading...
Need help?
General
