Icom IC-7400 User Manual

73
8
SCANS
2001 NEW
■ Tone scan/DTCS code scan operation
By monitoring a signal that is being operated with a re-
peater, tone squelch or DTCS, you can determine the
tone frequency necessary to open a repeater or the
squelch.
q Push [AM/FM] to select FM mode.
w Push [MENU] several times to select M1.
e Push [F4 TONE] for 1 sec. to enter tone set mode.
r Push [F1 TON] to select the tone type to be
scanned.
•“Rptr Tone” for repeater tone, “TSQL Tone” for
tone squelch and “DTCS Code” for DTCS code can be
selected.
•When selecting DTCS code to be scanned, push [F5]
several times to select the DTCS code polarity.
“NN” : Normal polarity for both transmit and receive.
“NR” : Normal polarity for transmit and reverse polarity
for receive.
“RN” : Reverse polarity for transmit and normal polarity
for receive.
“RR” : Reverse polarity for both transmit and receive.
t Push [F2 SCN] to start the tone scan function.
•“Rptr Tone SCAN,” “TSQL Tone SCAN” or
“DTCS Code SCAN” blinks when repeater tone scan,
tone squelch scan or DTCS code scan is operated, re-
spectively.
y When a matched tone or code is found, the scan
pauses and the tone frequency or code is set for the
selected tone as in step r.
When the tone scan or DTCS code scan is operated
in memory or call channel mode, the detected tone fre-
quency or code can be used temporarily.
To keep the detected tone frequency or code setting
for memory contents, you must over-write the memory
or call channel.
u Push [F2 SCN] to cancel the tone scan function.
•Rotating the tuning dial during scan also cancels scan
operation.
F 1
F 2 F 3 F 4 F 5
F 1
F 2 F 3 F 4 F 5
F 1
F 2 F 3 F 4 F 5
F 1
F 2 F 3 F 4 F 5
F 1
F 2 F 3 F 4 F 5
AGC DUP CMP TON SCP
TON
SCN 88.5Hz
Rptr Tone
TON SCN 88.5Hz
Rptr Tone SCAN
Push [F4] for 1 sec.
Push [F1] several times to select tone type.
• Repeater tone scan
• Tone squelch tone scan
• DTCS code scan
TON SCN 88.5Hz
TSQL Tone SCAN
TON SCN O23-NN
DTCS Code SCAN
Push [F2] to start/cancel the scan.
Push [F2] to start/cancel the scan.
Push [F2] to start/cancel the scan.
Push [F1] several times to select polarity.
IC-7400.qxd 02.4.2 11:35 Page 73

Icom IC-7400 Specifications

General

Brand	Icom
Model	IC-7400
Category	Transceiver
Language	English