6
OTHER FUNCTIONS
6-6
DTCS code squelch operation
The tone squelch opens only when you receive a
signal that includes a matching DTCS code in the
FM or FM narrow (FM-N) mode. You can silently
a reversed tone squelch function mutes the squelch
when you receive a signal including a matching DTCS
code.
Step. 1 Setting the DTCS code
1. Repeatedly push [V/M/C] to select the VFO mode.
2. Hold down [MODE] until a beep sound to select
an operating mode.
3. Set an operating frequency.
4. Push [SET].
5. Repeatedly push [SET] to select “codE.”
6. Rotate [DIAL] to set the DTCS code.
7. Push [V/M/C] to exit the Set mode.
Step. 2 Using the DTCS code squelch
1. Push [SET].
2. Repeatedly push [SET] to select “tOnE.”
3. Rotate [DIAL] to select a tone squelch type.
4. Operate normally.
L You will only hear the audio of stations using the
same DTCS code. All other signals will be muted.
DTCS codes indication
Reverse DTCS
DTCS Pocket Beep
DTCS code transmission
DTCS code squelch
TIP: Using the Pocket Beep function
sounds for 30 seconds and “ ” blinks.
L Confirm “P dtCS” is selected in the Set mode. (p. 5-3)
D About the DTCS polarity
You can select an option for the DTCS polarity in the
Set mode (p. 5-3).
To Next Page
Loading...
Need help?
General
