3
ADVANCED OPERATION
3-11
■ About the VOX function
The VOX function automatically switches between receive and transmit during voice operation.
When the VOX function is ON, speak into the headset microphone to transmit, then stop speaking to listen. In full-duplex,
you can speak and listen to the call-to party at the same time.
To use this function, an optional headset and a VOX converter cable, shown below are required.
L This function is set by your dealer.
L You can congure the setting in the Set mode. (p. 4-5)
NOTE:
Be sure to turn OFF the power before connecting or disconnecting optional equipment to or from the jack.
• Remove the cable by holding the plug not cable.
• Insert the plug securely when connecting the cable.
• Attach the jack cover when no optional equipment is connected.
L The jack is made tight to resist dust and water intrusion.
OPC-2006LS
(別売品)
HS-94
[マイク/スピーカー]
ジャック に 接 続 す る
Connector
cover
Plug
Jack cover is attachedAttaching an optional equipment
OPC-2006LS
(Option)
HS-94
(Option)
To the [MIC/SP] jack
To Next Page
Loading...
Need help?
General
