EasyManuals Logo

IDEAL LOGIC+ SYSTEM2 S30 User Manual

IDEAL LOGIC+ SYSTEM2 S30
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background image
34
Installation and Servicing
Section 2 - Installation
INSTALLATION
2.31 RESTART PROCEDURE
2.32 HANDING OVER
To restart the boiler, press the Restart button (A).
Restart Button
1 Check other gas appliances work.
2 Restart boiler.
3 If fault persists, contact installer.
Restart Menu
Ignition Lockout
Press
1 Check other gas appliances work.
2 Restart boiler.
3 If fault persists, contact installer.
Ignition Lockout
12. After installation and commissioning please complete
the Commissioning Checklist before handover to the
customer.
Refer to
Page 56
IMPORTANT
13. A comprehensive service should be carried out
annually.
Stress the importance of regular servicing by a Gas
Safe Registered Engineer.
14. Inform the householder of the boiler warranty and the
requirement to register it to receive the full benet.
1. Hand the Instructions to the householder and explain
their responsibilities under the relevant national
regulations.
2. Explain and demonstrate the lighting and shutting down
procedures.
3. Explain how to operated the boiler and system controls.
4. Ensure the greatest possible fuel economy consistent
with the household requirements of both heating and hot
water consumption.
5. Explain the precautions necessary to prevent damage to
the system and to the building, in the event of the system
remaining inoperative during frosty conditions. .
6. Explain the function and the use of the boiler heating and
domestic hot water controls.
7. Explain the function of the boiler fault mode.
8. Explain and demonstrate the function of timers and
temperature controls, radiator valves etc., for the
economic use of the system.
9. If a timer is tted draw attention to the timer Users
Instructions and hand them to the householder.
10. Explain that the dial behind the drop down door, indicates
the central heating system pressure and that if the normal
COLD pressure of the system is seen to decrease over a
period of time then a water leak is indicated. Explain the
re-pressurising procedure and if unable to re-pressurise
or if the pressure continues to drop a registered local
heating installer should be consulted.
Refer to Section
2.17
11. Explain boiler restart procedure.
Refer to Section
2.30
After commissioning the system, hand it over to the householder by the following actions:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDEAL LOGIC+ SYSTEM2 S30 and is the answer not in the manual?

IDEAL LOGIC+ SYSTEM2 S30 Specifications

General IconGeneral
BrandIDEAL
ModelLOGIC+ SYSTEM2 S30
CategoryBoiler
LanguageEnglish

Related product manuals