9. Maintenance and Inspection
- 262 -
9
Chapter 9 Maintenance and Inspection
9.1 Daily Inspection
Safety Information
WARNING
Ɣ
Do not connect or disconnect wiring while the power is on.
Ɣ
Disconnect all power and wait for several minutes. Do not touch any terminals
before the capacitors have fully discharged.
Ɣ
Do not modify or disconnect wiring, remove optional extension card or replace
the cooling fan while the power is on.
Ɣ
Make sure to connect the motor-side grounding terminal. Failure to comply
may result in electric shock due to touching motor housing.
Ɣ
'RQRWDOORZXQTXDOL¿HGSHUVRQQHOWRGRWKHUHSDLUPDLQWHQDQFHZRUN
Ɣ
Installation, wiring, commissioning, repair & maintenance, and component
UHSODFHPHQWPXVWEHSHUIRUPHGRQO\E\TXDOL¿HGWHFKQLFLDQV
CAUTION
Ɣ
Do not run the AC drive with front cover removed.
Ɣ
Drawings in the manual are sometimes shown without covers or protective
JXDUGV5HPHPEHUWRLQVWDOOWKHFRYHUVRUSURWHFWLYHJXDUGVDVVSHFL¿HG¿UVW
and then perform operations in accordance with instructions.
Ɣ
7LJKWHQDOOWHUPLQDOVFUHZVEDVHGRQVSHFL¿HGWLJKWHQLQJWRUTXH
Ɣ
Ensure that input voltage is within permissible range. Incorrect input voltage of
main circuit may result in abnormal running.
Ɣ
Keep combustible materials far away from the AC drive or mount the AC drive
on incombustible surfaces such as a metal wall.
Ɣ
5HSODFHWKHFRROLQJIDQLQFRUUHFWZD\VDVVSHFL¿HGLQWKLVFKDSWHU(QVXUH
correct air outlet direction of the fan. Incorrect air direction will diminish the
cooling effects.
Ɣ
Do not connect or disconnect motor while the drive is running. Failure to
comply may result in electric shock and damage to the AC drive.
Ɣ
Use shielded cables for control circuit wiring. Meanwhile, ground the shield to
the grounding terminal reliably.
Ɣ
Do not modify the drive circuitry. Failure to comply will damage the AC drive.
Ɣ Make sure to connect the output terminals of the AC drive and the motor
terminals correctly.
Ɣ
If it is necessary to change the motor rotation direction, exchange any two of
UVW cables of the AC drive.
Ɣ
Do not operate the AC drive that has been damaged. This is to prevent further
damage to external equipments.