Inovance MD290T45G/55P User Manual

2. Mechanical Installation
- 28 -
2
2.4 Installation Method and Procedures
Ƶ
Installation Method
The drive units enclosed in a sheet-metal housing (45 kW and above) have weights of 35 kg or
more. These units have eye bolts that allow a mechanical hoist to support the weight of the unit
GXULQJLQVWDOODWLRQ7RSUHYHQWSHUVRQDOLQMXU\RUGDPDJHWRWKHHTXLSPHQW\RXPXVW¿WDQGXVH
these eye bolts to support the drive during installation.
Mounting Method Applicable Housing Remark
Backplate
mounting
Plastic housing
Sheet metal housing
The AC drive is mounted directly on the backplate of
the cabinet . It is secured using four screws or bolts at
the corners of the backplate.
Through hole
mounting
Plastic housing
Sheet metal housing
It requires a cut-out in the backplate. The housing
must be secured in place by using the through-hole
mounting bracket and then be lifted into the cut-out.
The drives of MD290T200G to MD290T450G and MD290T220P to MD290T500P support
mounting in cabinet only.
Mounting Method Applicable Model Remark
Mounting in
cabinet
MD290T200G to
MD290T450G and
MD290T220P to
MD290T500P
,WUHTXLUHVLQVWDOODWLRQRI¿[LQJEHDPERWWRPPRXQWLQJ
EUDFNHWDQGJXLGHUDLO¿UVW7KH$&GULYHFDQEHWKHQ
pushed into the cabinet and secured.
2.4.1 Backplate Mounting
Note
It is very important that you identify correct mounting hole locations and diameters
RIWKHGULYH\RXDUHLQVWDOOLQJ$QGFKHFNWKDW\RXKDYHLGHQWL¿HGFRUUHFWGLPHQVLRQV
before you start to drill the mounting holes.
The backplate mounting process is as follows:
1. Select a suitable location. See recommendations in
2
.
1
I
n
s
t
a
l
l
a
t
i
o
n
E
n
v
i
r
o
n
m
e
n
t
.
CAUTION
Check that there are no items of equipment, cables or pipes behind mounting
surface that might be damaged when you drill mounting holes.
2. Measure and mark the drilling centers for the four mounting holes according to the
dimensions shown in
T
a
b
l
e
2
-
1
for your model of the drive.
3. Carefully drill the four mounting holes at the correct diameter as shown in
T
a
b
l
e
2
-
1
for your
model of the drive.
4. If necessary, lift the drive to the installation location. Hold it in correct position until there are
¿[LQJVLQSODFHWRVHFXUHLWVDIHO\
 $GGORFNLQJZDVKHUVDQGÀDWZDVKHUVWRWKHVHFXULQJEROWVRUVFUHZVLQVHUWWKHPWKURXJK
the four mounting holes in the housing, and tighten them to secure the housing to the
backplate.

Inovance MD290T45G/55P Specifications

General

Brand	Inovance
Model	MD290T45G/55P
Category	DC Drives
Language	English