5.7 Inspection Running:
Now the Lift is ready for Inspection running. Please refer content of 5.2 (Page-18) for MCB’s
LED sequence for Inspection operation
Make sure that the all safety switches are connected and functioning properly
Make sure that the Up & Down terminal Limit and terminal slowdown switches are wired up
and located in the right position as given in the manual
Use the UP and DOWN Button in the Inspection board on controller/Car-Top to run the lift in
Inspection speed.
Check the direction of the lift running. X5 LED in the Main Control Board (MCB) glows when UP
button is pressed. During this time, lift should run in UP direction and for DOWN button, X6
LED glows and lift runs in Down direction.
If the running direction is wrong, then modify the parameter F2-10(1↔2, 0↔3)
If Err20 comes after some distance travelled in Inspection mode, then modify the parameter F2-10
(0↔2, 1↔3). (For Geared lift, interchange PG-A and PG-B wires)
If the system gives Err20 and the direction of running is also wrong, then modify the F2-10
(0↔1, 2↔3)
6. Normal/High Speed operation
6.1 Elevator Shaft Learning Process:
Ensure that the hoist-way top and bottom slowdown terminal, Direction Limits switches and floor level
magnetic plates or flags are installed correctly before performing shaft self-learn.
Floor level switch cutting plates/flags (Door Zone):
To Next Page
Loading...
Need help?
General
