www.insigniaproducts.com
9
4.8 Cu. Ft. Gas Convection Range with Self Clean and Air Fry
INSTALLATION WARNINGS
Any adjustment and service should be performed only by qualified gas range installers or service
technicians.
Be sure your range is correctly installed and adjusted by a qualified service technician or installer for the
type of gas (natural or LP) that is to be used. To utilize LP fuel source, the 5 surface burner orifices, 2 oven
orifices must be exchanged with the provided LP orifice set, and the GPR adapter must be reversed.
These adjustments must be made by a qualified service technician in accordance with the
manufacturers instructions and all codes and requirements of the authority having jurisdiction. Failure
to follow these instructions could result in serious injury or property damage. The qualified agency
performing this work assumes responsibility for the conversion.
Do not attempt to repair or replace any part of your range unless it is specifically recommended in this
manual. All other service should be referred to a qualified technician.
This appliance must be properly grounded. Plug your range into a 120- volt grounded outlet that is only
used for this appliance. Do not remove the grounding (third) prong from the plug. Firmly plug the
power cord into the wall outlet. If you are not sure your electrical outlet is grounded, it is your personal
responsibility and obligation to have a properly grounded, three-prong outlet installed in accordance
with local and national codes. Do not use a damaged power plug or loose wall outlet. Do not use an
extension cord with this appliance. In addition, do not use an adapter or otherwise defeat the
grounding plug. If you do not have a proper outlet or have any doubt, consult a licensed electrician.
Locate the range out of kitchen traffic paths and drafty locations to prevent poor air circulation.
This appliance should be positioned in such a way that the power plug is accessible.
Do not install in an area exposed to dripping water or outside weather conditions.
Remove all packaging materials from the range before operating it. These materials can ignite, causing
smoke and/or fire damage.
Install this appliance on a level and hard floor that can support its weight. Synthetic flooring, like
linoleum, must withstand 180° F (82° C) temperatures without shrinking, warping, or discoloring. Never
install the range directly over interior kitchen carpeting unless a sheet of 0.25-inch plywood or similar
insulator is placed between the range and carpeting.
Never block the vents (air openings) of the range. They provide the air inlet and exhaust necessary for
the range to operate properly with correct combustion.
Air openings are located behind the range, under the oven control panel, at the top and bottom of the
oven door, and under the storage drawer.
Large scratches or impacts on door glass can cause the glass to break or shatter.
Make sure the wall coverings around the range can withstand heat, up to 200° F (93° C), generated by
the range.
Avoid placing cabinets above the range. This reduces the hazard caused by reaching over the open
flames of operating burners.
If cabinets are placed above the range, allow a minimum clearance of 40 in (102 cm) between the
cooking surface and the bottom of unprotected cabinets.
Install a ventilation hood or an externally vented Over The Range Microwave Oven over the range
cooktop that is as wide as the range, centered over the range, and projects forward beyond the front of
the cabinets.
Remove all tape and packaging. Make sure the burners are properly seated and level.
Remove any accessories from the oven and/or lower drawer.
Check to make sure no range parts have come loose during shipping.
Seal any openings in the wall behind the appliance and in the floor under the appliance after the gas
supply line is installed.
To Next Page
Loading...
Need help?
General
