System-Related Functions
Prompt information for reverse connection protection. All prompt interfaces can
be exited by pressing the [Esc] key.
• No SDS Module detected: Under the battery charge/discharge mode, if the
prompt is given when the On/Off key on the front panel is pressed and SDS
is not inserted, the user can select to continue the execution or detection of
SDS module.
• DC Port No Voltage: The prompt is given in the case of reverse connection
or abnormality at the DC terminal.
• Sense Port No Voltage: The prompt is given in the case of reverse connec-
tion or abnormality at the Sense terminal.
• Surge Suppressing: The prompt is given when the surge suppress is oper-
ated with command or when a battery with certain voltage is correctly con-
nected for surge suppress under the battery test mode.
• Surge Suppress Done: The prompt is given when the surge suppress opera-
tion is succeeded.
• Surge Suppress Fail: The prompt is given when the surge suppress opera-
tion is failed.
• Error: Module conflict: When the user attempts to connect several machines
in parallel, if any two machines are of not same models, the master unit
would give prompt until all modules are consistent. During this period, the
output and input cannot be turned on by the master unit, and the power and
load modes cannot be switched. However, the user can enter the System
menu to configure related parameters.
Copyright © Itech Electronic Co., Ltd.
92
To Next Page
Loading...
Need help?
General
