Output Function
4.3 Set the Output Current
The current setting range is between negative full rated to positive full rated
output current. When the [I-set] key is pressed, the light will be lit. At this time,
the current setting value flashes and the current value can be set.
• Under CV priority, press [I-set] to set current value, and repeat press [I-set]
to set positive limit or negative limit. the limit limits the output current to a
specified current range.
• Under CC priority, press [I-set] to set the current value.
4.4 Set the Output Power
The power setting range is from 0W to the maximum rated output power. When
[P-set] key is pressed, the key light is lit and the output power value can be set.
Press right and left keys to move the cursor and rotate the knob to adjust the
value in the power setting filed anf press [Enter] to confirm.
4.5 Set Output Slope
This series instrument is supported setting the V-Rise Time/V-Fall Time under
CV priority mode and I-Rise Time/I-Fall Time under CC priority mode. The slope
is the time for one voltage/current point to rise/fall to the other point under the
output status is ON.
The instrument displays different slope paremeters accroding present CC or CV
priority.
• When CV priority mode: displays V-Rise Time and V-Fall Time.
• When CC priority mode: displays I-Rise Time and I-Fall Time.
The following takes the CV priority mode as an example to introduce the
operation of setting slope, the setting method under CC priority mode is
the same.
1. Press [Shift]+[V-set](Config) to enter into the configuration menu interface.
2. Rotate the knob to select V-Rise Time and press [Enter] to confirm.
3. Use left and right keys or knob to setting the V-Rise Time and press [Enter]
to confirm.
4. Rotate the knob to select V-Fall Time and press [Enter] to confirm.
Copyright © Itech Electronic Co., Ltd.
47
To Next Page
Loading...
Need help?
General
