To Next Page

To Previous Page

Getting Started

Error Messages Description

Wait For Master The instrument is waiting the

master.

EEProm Failure EEProm is broken.

The instrument takes approximately 30 seconds to initialize before it is ready

for use.

Turning the POWER Switch Off

Flip the POWER switch to the ( O ) side to turn the instrument off. When it is

turned off, the instrument interface will prompt “Power Down”, and the

instrument will store the setting information before shutdown in the group 1 non-

volatile memory.

After you turn the POWER switch off, wait at least 10 seconds after the fan

stops before you turn the POWER switch back on. Turning the instrument on

too soon after you turn it off can cause damage to the inrush current limiter

circuit, as well as reduce the life of components such as the POWER switch and

the internal input fuses.

3.2 Set output parameters

The voltage value, current value and power value can be programmed, which

can be set to different parameters within the specification range based on cus-

tomer requirements. This can meet various test requirements of the customer.

After the user selects the Running mode on the front panel, the instrument inter-

face displays the parameters to be set under the existing running mode, and the

cursor flashes for prompt. Or, press the knob to set parameters.

The pressing knob is introduced below.

• Rotate the knob to set the data value at the cursor. The set value is in-

creased with crosswise rotation, and decreased with counterclockwise rota-

tion. When the knob is rotated to set parameters, automatic carrying is made

ITech IT-M3412 User Manual

Questions and Answers: