Power Supply Function
• The first line shows the voltage and current Meter values in real time.
• The second line shows the present battery capacity and the actual state of
charge (SOC).
Stop Battery Simulation Test
As the battery simulation test runs, the SOC value is constantly changing:
• When the SOC rises (simulated charge), the voltage will also rise. When the
voltage reaches full voltage (Full Voltage), the voltage will continue to rise.
If you want to stop testing when the voltage reaches full voltage, turn on the
OVP function and set the OVP level to the full voltage value. See 4.5.1 Set
Over-Voltage Protection (OVP) for details.
• When the SOC drops (simulated discharge), the voltage will also drop.
When the voltage reaches empty voltage (Empty Voltage), the voltage will
continue to drop.
If you want to stop testing when the voltage reaches empty voltage, turn on
the UVP function and set the UVP level to the empty voltage value. See
4.5.5 Set Under-Voltage Protection (UVP) for details.
If you want to stop running during the battery simulation test, you can do the fol-
lowing: Press the composite keys [Shift]+[I-set] (Function) on the front panel to
enter the function menu.
At this point, the interface will prompt whether to stop the running of the Func-
tion, you can press the Left/Right key to select Stop, then the running will be
stopped, and the Function menu item will be displayed, you can re-enter the
Function menu for editing; if Reset is selected, it means to stop the present run-
ning and return to the main interface to wait for the next trigger operation; if
Pause is selected, it means that the present running is suspended, and you can
continue to run by selecting Resume.
Copyright © Itech Electronic Co., Ltd.
148
To Next Page
Loading...
Need help?
General
