Power Supply Function
4 Power Supply Function
This chapter describes the functions and features of the power system in
Source mode. Divided into the following sections:
♦ Set the Output Voltage
♦ Set the Output Current
♦ Set the Output Power
♦ Config Menu for Power Supply
♦ Protection Function for Power Supply
♦ Function Menu for Power Supply
4.1 Set the Output Voltage
In CV priority (default) mode, press [V-set], the interface displays “Vs=0.00V”
(Setting value of voltage). In CC priority mode, press [V-set], the interface dis-
plays “Vh=0.00V” (Upper limit of voltage), and press [V-set] again, the interface
displays “Vl=0.00V” (Lower limit of voltage).
The voltage setting range is from 0V to the maximum rated output voltage.
When [V-set] key is pressed, the key light is lit and the output voltage value can
be set. Press numeric keys or rotate the knob to adjust the value in the voltage
setting area indicated by the cursor. This value takes effect when you press
[Enter].
4.2 Set the Output Current
In CV priority (default) mode, press [I-set], the interface displays “I+=0.00A”
(Upper limit of current) , and press [I-set] again, the interface displays “I-= –
0.00 A” (Lower limit of current). In CC priority mode, press [I-set], the interface
displays “Is=0.00A” (Setting value of current).
The range of current settings is between the data ranges defined in the specifi-
cations. When [I-set] key is pressed, the key light is lit and the output current
value can be set. Press numeric keys or rotate the knob to adjust the value in
the current setting area indicated by the cursor. This value takes effect when
you press [Enter].
Copyright © Itech Electronic Co., Ltd.
55
To Next Page
Loading...
Need help?
General
