Basic Operation
• On: Default value, indicates the beeper is on.
• Off: Indicates the beeper is off.
4. After the parameter settings are complete, press [Enter].
At this point, the beeper status takes effect immediately.
6.6 Set the Power-on State (PowerOn)
This menu item is used to control the settings and output state when the power
system is powered on.
The detailed power-on parameters and output state are as follows.
• The voltage, current, power, resistance setting values displayed on the main
interface when the instrument is powered on.
Only in the Load mode, the resistance setting value will be displayed.
• And, whether the instrument works in Source or Load mode.
• Parameter setting values in the Config menu.
• The output state of the power system, i.e., the [On/Off] key state.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the PowerOn and press
[Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• Reset: Default value, indicates when the instrument is powered on, the
instrument will initialize some parameter settings or state.
The affected parameters and the reset information are as shown in the
following table.
Copyright © Itech Electronic Co., Ltd.
176
To Next Page
Loading...
Need help?
General
