To Next Page

To Previous Page

Inspection and Installation

5. Thread the red and black test cables through the output terminals cover of

the power system and install the cover.

6. (Optional) According to the actual situation of DUT, connect the grounding

terminal on the rear panel of the instrument to the DUT to ensure the safe

grounding.

For the location information, see 1.5 Rear Panel Introduction.

7. Connect the other end of the remote sense cables to the DUT.

8. Connect the other end of the red and black cables to the DUT. The positive

and negative poles must be properly connected and fastened when wiring.

9. Power on the instrument and turn on the Sense function of the instrument.

For details, see 6.7 Sense Function (Sense).

Never touch cables or connections immediately after turning off

the instrument at the end of the test. Lethal voltages may remain

at the output terminals after turn-off. Verify that there is no dan-

gerous voltage on the output or sense terminals before touching

them.

2.6 Remote Interface Connection

This series power system comes standard with four communication interfaces:

USB, LAN and CAN, and supports two optional communication interfaces:

GPIB, RS-232. You can choose one of them to communicate with your

computer.

When you use the remote interface to send SCPI instructions, if you use the

programming commands that involve modifying the instrument settings, such

as modifying the output voltage value, after completing the communication

connection between the instrument and the host computer, and after the

communication settings are completed, you must execute the SYST:REM

command firstly.

2.6.1 USB Interface

The USB interface is located on the rear panel of the instrument. You can con-

nect the instrument to the computer via a cable with a USB interface on both

ends (USB A-type connector on one end and USB B-type connector on the

other).

The user needs to select the USB interface type in the System menu before us-

ing the USB interface. The following types are optional.

• TMC: USB_TMC interface;

ITech IT6000B Series User Manual

Questions and Answers: