ITech IT6000D Series User Manual

Quick Reference
analog interface
share an inter-
face position.
Parity
Parity bit: N (No parity) / E (Even parity) / O
(Odd parity)
Stopbit Stop bit: 1/2
GPIB Select GPIB communication interface.
Address
Set the communication address (1 to 30).
Parallel
Set the instruments to parallel operation mode.
Single
Set the instrument to single mode, i.e., disable the parallel
operation mode.
Master Set the instrument to master mode.
Total Unit
Number of parallel instruments.
Slave Set the instrument to slave mode.
Digital Port
Set Digital I/O
By default, the menu item displays 7 options. You can set parameters
for each option respectively. After setting, the corresponding change to
each option becomes valid immediately. When re-entering DigPort,
the interface can display the changed option. For detailed introduction
of menus and functions, see 5.11 Digital I/O Function (Digital Port).
IO-1. Ps-Clear, Not-
Invert
Function setting of pin 1
IO-2. Ps, Not-Invert
Function setting of pin 2
IO-3. Off-Status, Not-
Invert
Function setting of pin 3
IO-4. Ext-Trig, Not-
Invert
Function setting of pin 4
IO-5. INH-Living, Not-
Invert
Function setting of pin 5
IO-6. Sync-On, Not-
Invert
Function setting of pin 6
IO-7. Sync-Off, Not-
Invert
Function setting of pin 7
Ext-Program
External Analog Function. This function is optional. The menu can only
display when corresponding board card is inserted. For details, see
5.12 Analogue Function (Ext-Program) (Optional).
System Reset Select whether to restore the factory default settings or not.
System Rzero
Used to control whether the voltage is quickly zeroed after the output is
turned off.
• Off: No
• On: Yes
System Info
View the system information. For details, see 5.14 View the System In-
formation (System Info).
Copyright © Itech Electronic Co., Ltd.
15

ITech IT6000D Series Specifications

General

Brand	ITech
Model	IT6000D Series
Category	Power Supply
Language	English