ITech IT6512 User Manual

Remote Control
Copyright ©ITECH Electronic Co., Ltd. 37
RS-232 Troubleshooting:
If you meet some problems when communicating with PC by RS232 interface,please
check the following items:
 Please check the parameters setting
PC and power supply must have the same configuration in the following items:
baudrate, parity bit,data bit and flow control.Please note that power supply has been
configured with a start bit and stop bit(the two values are fixed).
 Check the cable
Ensure you have used the correct communication cable.Please pay attention that some
cable may not have a correct internal wiring even it is with a appropriate DB9
interface.
The RS232 communication cable should have been connected to a correct serial port
of the PC.
Communication Setup
Please ensure the PC and power supply have the same configuration in the following
items.
baudrate: 9600(4800, 9600, 19200, 38400, 57600, 115200).You could enter the system
menu to set the baudrate.
Data bit: 8
Stop bit: 1
Parity bit: (none, even, odd)
EVEN 8 data bits have even parity
ODD 8 data bits have odd parity
NONE 8 data bits have no parity
Native machine address: (0 ~31, factory default is 0)
Parity= None Start Bit 8 Data Bits Stop Bit
4.2 USB Interface
Use a cable with two USB ports to connect power supply and PC.You can program
through USB interface to achieve all functions of power supply.
The functions of USB488 interface are as follows:
 Interface is 488.2 USB488 interface
 Receive the following request: REN_CONTROL, GO_TO_LOCAL, and
LOCAL_LOCKOUT
 When the interface receives MsgID = TRIGGER USBTMC command,it will
transmit the TRIGGER command to the function layer
The functions of power supply’s USB488 are as follows:
 receive all SCPI commands
 device is SR1 enabled
 device is RL1 enabled
 device is DT1 enabled

ITech IT6512 Specifications

General

Brand	ITech
Model	IT6512
Category	Power Supply
Language	English