14
House heating settings in areas 0 to 10. See more detailed
description in “Heat Settings” chapter.
Fine adjustment settings in areas -10°C to 10°C. See more
detailed description in “Heat Settings” chapter.
Here you can set the heat in areas 0 to 10 if you use an
extra heat curve with a mixing valve.
Here you set the fine adjustment of the mixing valve curve
in –10°C to 10°C.
If a room sensor is connected you can set the required
room temperature here. On customer level 2 you can set
how much you want the sensor to affect the heating sys-
tem.
You can temporarily increase the hot water temperature
with the electric water heater here. The heat pump first
increases it to around 50°C and then the electric water
heater to around 65°C. The electric heater starts again at
60°C and increases the temperature to 65°C in the set
time. The area is 1-48 hours and when the set time has
elapsed the settings must be repeated in order to receive
extra hotwater.
With extra
sensor
only.
With
extra
sensor
only.
With
extra
sensor
only.
Operat-
ing mode
A only.
The radiator temperature settings you make in the short cut
to “Heat” can also be made on row 1 and for the hot water
setting on row 2.
In row 3 you can see all the temperatures where sensors
are connected.
Main menu
Monitor all
temperatures 3
Return Select
Main menu
Indoor temperature
settings 1
Return Select
Extra hotwater
1h 0h 48h
Return Adjust
Room temperature
10° 20° 30°
Return Adjust
Mix. valve fine-tune
-10° 0,0° 10°
Return Adjust
Mix. valve incr/decr
0 4 10
Return Adjust
Temp. fine-tune
-10° 0,0° 10°
Return Adjust
Temp. incr. / decr.
0 4,0 10
Return Adjust
Basic functions (customer level 1)
Heating and extra hot water
Press “Heat” to come to the short cut to the heat settings. These
displays are then available.
Rego600 K1
020301 12:00:00 Fr
Heat Info Menu
Temperatures
Press “Menu” to come to the main menu. Where you can also carry
out heat settings and see the temperatures. These displays are then
available.
To Next Page
Loading...
Need help?
General
