16
Line 4
You have now moved to timer control settings line 4.
Here you can set the times, day for day, that you want to
utilise the clock settings. You can set all the weekdays
independently of each other. Press “Select”.
The example describes how you set Monday between
22:00 and 06:00. Press “Adjust”.
There is now a cursor under Monday. Turn the dial and mo
becomes Mo. Monday is now activated.
Now set the clock setting to between 22:00 and 06:00 in
the morning. Press the right arrow button until the cursor is
under the first 00. Turn the dial until 22:00 appears. Press
the button twice more (the cursor moves two steps to the
right) and turn the dial until 06:00 appears. Press the ”right
arrow” button once more and the arrow is replaced by
“Save”. Press “Save” to set the timer controls.
You can now do the same for all the other days of the
week you want to timer control. Use the dial in this display
to access other days.
In display 4.1.1 you set how much you want the tempera-
ture to be raised or lowered in the above time zone set-
tings. If you choose, for example, –5°C the heating system
temperature is lowered by 5°C.
In display 4.3 you can disconnect the hot water completely
during e.g. peak rate times. This is done in the same way as
with the heat pump time controls.
Not
operating
mode C
Tidsstyrning
Tidsstyrning tillsk.
enligt klocka 4.2
Tillbaka Välj
Clock setting
Setting level
heat pump +/- 4.1.1
Return Select
Clock setting HP 1
Mo 22:00-06:00
Return Adjust
Clock setting HP 1
Mo 22:00-06:00
^^
Cancel <- ->
Clock setting HP 1
Mo 00:00-00:00
^^
Cancel ->
Clock setting HP 1
mo 00:00-00:00
Return Adjust
Clock setting
Clock setting HP
accord. to clock 4.1
Return Select
Main menu
Timer control
settings 4
Return Select
To Next Page
Loading...
Need help?
General
