21
07610-002-23-32-AC
For the rst operation of each day, it might be necessary to run the machine through
three cycles to ensure that all of the cold water is out of the system and to verify that
the unit is operating correctly. To cycle the machine, ensure that the power is on and
that the tub has lled to the correct level. Lift the door and the cycle light will illuminate.
When the light goes out, close the door, the unit will start, run through the cycle, and
shut-off automatically. Repeat this two more times. The unit should now be ready to
proceed with the washing of ware.
To wash a rack, open the door completely (avoiding hot water that might drip from
the door) and slide the rack into the unit.
Close the door and the unit will start automatically. Once the cycle is complete,
open the door (again watching for the dripping hot water) and remove the rack of
clean ware. Replace with a rack of soiled ware and close the door. The process will
repeat itself.
Based upon usage, the scrap screen might become clogged with soil and debris
as the workday progresses. Operators should regularly inspect the scrap screen to
ensure it has not become clogged. If clogged, it will reduce the washing capability of
the machine. Instruct operators to clean-out the scrap screen at regular intervals or
as required by workload.
1. Turn machine off by flipping the “Power On/Power Off” switch to “OFF.”
2. Open the door and allow steam/heat to escape.
3. Remove the standpipe and allow the tub to drain.
WARNING! Wash tank water will be hot!
WARM-UP CYCLES
WASHING A RACK
OF WARE
OPERATIONAL
INSPECTION
SHUTDOWN &
CLEANING
!
WARNING
OPERATING INSTRUCTIONS
OPERATION
To Next Page
Loading...
Need help?
General
