Page 10
5.0 Electrical Installation Instructions (240V Service)
IMPORTANT NOTICE: The electrical wiring of this spa must meet the
-
cable state or local codes. The electrical circuit must be installed by a
-
tion authority.
1. This spa must be permanently connected (hard-wired) to the power
supply. No plug-in connections or extension cords are to be
used in conjunction with the operation of this spa. Supplying
power to the spa which is not in accordance with these instructions
will void both the independent testing agency listing and the manu-
2. The power supplied to this spa must be a dedicated circuit with no
other appliances or lights sharing the power provided by the circuit.
3. To determine the current, voltage and wire size required, refer to sec-
• We recommend type THHN wire.
Do not use
aluminum wire.
spa and reduce to short lengths of #8 (8.4mm²) wire to connect to
the spa.
4. The electrical supply for this product must include a suitably rated
water.
5. The electrical circuit supplied for the spa must include a suitable
screws securing the center cabinet panel on the side of the spa
under the controls. Then remove the four control box door screws
To Next Page
Loading...
Need help?
General
