Page 116
J-400
WARNING: RISK OF ELECTRICAL SHOCK HAZARD
EXISTS AND EQUIPMENT DAMAGE! Never install or
remove iPod while hands are wet or while sitting partially
immersed or fully immersed in spa!
9. Error has occurred
If the remote senses an error that needs attention, it will dis-
play the words “Spa” - “Err”, one word at a time, (see Figure
J). The words will cycle for 1 second each. Please go to the
main spa control panel for further instructions. If this error is
not detected by the user within 20 seconds, the remote will
go to sleep mode and the backlighting will begin to ash on
and off until a key is pressed.
1. Turn the remote unit over and locate the battery
door (Figure A).
2. Remove the six screws securing the door.
3. Remove the battery door. You could use a small screwdriver to pry
the door upward.
4. Replace or install 3 AAA batteries.
5. Reinstall the battery door and screws.
Note: Remote unit is water resistant not waterproof, therefore the unit
should be stored in a dry location within your home and never be left in
the spa while the cover is on and spa is not in use.
Figure J
Figure A
Figure B
Figure C
To Previous Page
Loading...
Need help?
General
