Page 67
J-400
4. If you have programmed the Auto-
Heating cycle you will see the
Thermometer with wavy lines icon
next to word Heating on the display
(Figure F).
12.3 Programmable Heating Mode
Programmable heating mode is typically
selected by customers in warm climates
where heat up times are minimized due
to higher ambient temperatures. In this
mode, the water temperature is regulated
by the set temperature only when a
programmed heating cycle is running,
unless in summer logic page 72.
From the Heating Menu (Figure B, page 66), use the Quad Keypad
Down button to select the programmable setting, then press the Splash
button to enable selection, Figure G.
A. Program A Heating Mode
1. You are allowed to have two
separate programs in the
programmable mode, you can elect
to use both or just one. Press the
Splash button to enter the submenus
for “Program A” (Figure H).
2. From this menu (Figure I), you can
set the days, times, and duration.
With “Day Settings” selected press
the Splash button on the Quad
Keypad to access the submenus.
3. When you enter the submenu
(Figure J), you can choose the
day(s) you would like “Program A” to
run for a heating cycle. Press the Up
or Down button (on the Quad
Keypad) to scroll through and
choose the days you would like the
heater to activate. Press the Left or
Right button to turn “ON” ( ) or
“OFF” the heater for that day.
Press to
set filter or UV timer
Heating
UV Light
Filter
OFF
0 Days
SETTINGS 1
1
2
Figure F
HEATING
Press to Set
Select
Auto-Heating
2
Eco-Mode
Programmable
Figure G
PROGRAMS
Program A
Press to Enter
Select
Program B
A
Program A
2
Figure H
Figure I
PROGRAM A
Start Time
Day Settings
Duration
Select
Day Settings
Press to Enter
2
A
Figure J
Select
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
Press to Save
Monday
OFF
OFF
OFF
OFF
OFF
OFF
PROGRAM A
2
A
To Next Page
Loading...
Need help?
General
