27
N1:253 N2:224
M1 00001 01/13 1
Starting to Embroider
z Select the pattern you wish to sew. The LCD
screen shows the Ready to sew mode display.
NOTE:
The embroidery result may vary depending on the
fabric and threads used. Make a test embroidery
using the same fabric and threads before sewing on
the actual garment.
x Press the ENTER button to check the thread color
assigned to each needle bar. The screen will show
the needle bar number and color code.
q ENTER button
w Needle bar number
e Color code
Adjust the hoop position by pressing the arrow
buttons if necessary.
r Arrow buttons
c To check the needle drop position, lower the
needle bar with the small screwdriver so you can
see the needle point closer to the fabric.
Push down the needle bar using the
screwdriver while pressing it against the needle
clamp as illustrated.
The needle bar can be lowered by turning the
handwheel clockwise.
CAUTION:
Make sure to bring the needle bar and presser foot to
the up position by pressing the auto thread cutter
button before pressing the trace button or turning the
machine off.
v Press the trace button to check the size and
position of the selected pattern against the hoop.
t Trace button
NOTE:
Check if the fabric edge will not obstruct the
movement of the
q
w
e
r
t
z
x
c
v
To Next Page
Loading...
Need help?
General
