8 - 1
Removing and Fitting a Side Panel
!!
WARNING
The loader arms must be raised and locked before you
remove an engine side panel. Keep the arms locked up
until the side panel is put back. If you do not lock the
loader arms, the shovel can fall and you could be
crushed. See Loader Arm Safety Strut in MAINTENANCE
section.
2-3-1-4/1
!!
WARNING
Do not remove the engine side panel while the engine is
running.
2-3-1-5
1 Raise and Lock the Loader Arms.
See Loader Arm Safety Strut.
2 Stop the Engine
Remove the starter key.
3 Raise the Bonnet.
See Opening and Closing the Bonnet.
4 Remove the Side Panel
Lift the side upwards and outwards.
5 Fit the Side Panel
Carefully slot the side panel into position, locating the
inner catch. Lower and lock the bonnet. See Opening
and Closing the Bonnet.
Opening and Closing the Bonnet
To release the bonnet, insert key A into the bonnet lock and
turn 90° clockwise.
Open the bonnet until the latch is engaged.
To close the bonnet, release the latch and lower the bonnet.
To lock the bonnet, insert key A into the bonnet lock and
turn 90° anticlockwise.
Section 3 Routine Maintenance
9803/7130
Section 3
8 - 1
Issue 1
Engine Panels
391740
AA
To Next Page
Loading...
Need help?
General
