• Each time the ignition is placed in the ON/RUN posi-
tion, the ESC system will be ON, even if it was turned off
previously.
• The ESC system will make buzzing or clicking sounds
when it is active. This is normal; the sounds will stop
when ESC becomes inactive following the maneuver
that caused the ESC activation.
This telltale indicates that an ESC event is active.
— Electronic Stability Control (ESC) OFF
Indicator Light — If Equipped
This light indicates the Electronic Stability Control (ESC) is
off.
— Forward Collision Indicator Light — If
Equipped
This telltale will turn on warn you of a possible collision
with the vehicle in front of you.
Forward Collision Warning Off Indicator Light —
If Equipped
This light indicates that Forward Collision Warning is off.
White Indicator Lights
— Cruise Control ON Indicator
This light will turn on when the speed control is on, but not
set.
— LaneSense Indicator Light — If Equipped
When the LaneSense system is ON, but not armed, the
LaneSense indicator is solid white. This occurs when only
left, right, or neither line has been detected. If a single lane
line is detected, the system is ready to provide only visual
warnings if an unintentional lane departure occurs on
detected lane line. Refer to “LaneSense — If Equipped⬙ in
“Starting And Operating” for further information.
— Hill Descent Control (HDC) Indicator Light —
If Equipped
This indicator shows when the Hill Descent Control (HDC)
feature is turned on. The lamp will be on solid when HDC
is armed. HDC can only be armed when the transfer case is
in the “4WD LOW” position and the vehicle speed is less
then 30 mph (48 km/h). If these conditions are not met
while attempting to use the HDC feature, the HDC indi-
cator light will flash on/off.
4
GETTING TO KNOW YOUR INSTRUMENT PANEL 129
To Next Page
Loading...
Need help?
General
