— Stop/Start Active Indicator Light — If
Equipped
This telltale will illuminate when the Stop/Start function is
in “Autostop” mode.
— Automatic High Beam Indicator Light — If
Equipped
This indicator shows that the automatic high beam head-
lights are on.
Blue Indicator Lights
— High Beam Indicator Light
This indicator shows that the high beam headlights are on.
With the low beams activated, push the multifunction lever
forward (toward the front of the vehicle) to turn on the
high beams. Pull the multifunction lever rearward (toward
the rear of the vehicle) to turn off the high beams. If the
high beams are off, pull the lever toward you for a
temporary high beam on, ⬙flash to pass⬙ scenario.
Gray Indicator Lights
— Electronic Speed Control ON Indicator Light
This light will turn on when the electronic speed control is
ON.
ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated Onboard
Diagnostic system called OBD II. This system monitors the
performance of the emissions, engine, and automatic trans-
mission control systems. When these systems are operating
properly, your vehicle will provide excellent performance
and fuel economy, as well as emissions well within current
government regulations.
If any of these systems require service, the OBD II system
will turn on the Malfunction Indicator Light (MIL). It will
also store diagnostic codes and other information to assist
your service technician in making repairs. Although your
vehicle will usually be drivable and not need towing, see
an authorized dealer for service as soon as possible.
CAUTION!
• Prolonged driving with the MIL on could cause
further damage to the emission control system. It
could also affect fuel economy and driveability. The
vehicle must be serviced before any emissions tests
can be performed.
(Continued)
GETTING TO KNOW YOUR INSTRUMENT PANEL 131
To Next Page
Loading...
Need help?
General
