Installation Instructions
Introduction
READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING THE INSTALLATION. CLOSE ATTENTION
TO THE DETAILS OF INSTALLATION WILL ENABLE YOU TO GET THE BEST RESULTS FROM YOUR
FIRE.
NOTE: THESE INSTRUCTIONS SHOULD BE RETAINED FOR FUTURE REFERENCE.
Dimensions
The installation data table contains all the dimensional information necessary to allow the installation to be
properly planned.
Regulations
In the United Kingdom the installation must be in accordance with:-
●
The Building Regulations issued by the Department of the Environment or the Building Standards (Scotland)
(Consolidation) Regulations issued by the Scottish Development Department.
●
All relevant codes of practice and relevant parts of any local regulations, including those referring to National
and European standards.
●
In your own interest and for safety, in the United Kingdom, it is the law that all solid fuel appliances are
installedbycompetentpersons,aregisteredinstallerorapprovedbyyourlocalbuildingcontrolofcer.The
Heating Equipment Testing and Approval Scheme (HETAS) require its members to work to recognised
standards.
●
In other countries the installation must also conform to the national and local regulations in force. This may
include only the use of permitted fuels in some countries.
THIS APPLIANCE IS DESIGNED AND APPROVED TO BURN WOOD WITH THE DOOR CLOSED.
THIS APPLIANCE IS NOT DESIGNED TO BURN GAS.
THIS APPLIANCE IS NOT DESIGNED TO BE FITTED INTO BOATS.
A. The chimney must be swept and of correct dimensions, be suitable for use with a wood burning stove and
be terminated clear of any possible wind effects.
B. There must be an adequate supply of air into either the appliance if an external air supply is used, or
adequate air supply into the room if an external air supply is not used.
6
To Next Page
Loading...
Need help?
General
