– 93 –
2. Set a "threshold" for the multi-layered
section detection.
1) Press ❹.
The "multi-layered section threshold setting
screen" is displayed.
2) Place the normal section of material under the presser foot, and press ❺.
Lift the presser foot by depressing the back part of pedal.
3) Place the multi-layered section of material under the presser foot, and press ❻.
The value of ❼ is automatically calculated, and that value becomes the "threshold" for the multi-layered
section detection. The value is adjustable with
according to the sewing item.
If the "threshold" is decreased, the multi-layered section can be detected earlier. Be aware
that, excessively decreased threshold can cause a faulty detection.
Press
❽
to display the "multi-layered section detection sensor value screen".
<Multi-layered section detection sensor value screen>
<段部検知 しきい値設定画面>
<段部検知 しきい値設定画面>
❹
❺
❻
❼
❽
<Multi-layered section threshold setting screen>
<Multi-layered section threshold setting screen>
To Next Page
Loading...
Need help?
General
