– 116 –
8-5. Condensation custom pattern
Condensation stitches can be sewn while specifying needle
entry points as desired, by setting a condensation custom.
As many as 20 steps can be created in one condensation
custom pattern. For each step, as many as nine different
patterns of start and end of sewing can be registered.
8-5-1. Selecting the condensation custom
Select condensation custom pattern referring to "4-2-3.(2)
◆
For the maintenance personnel mode" p.38.
The condensation custom pattern for reverse-feed stitching at the end of sewing can be set in the similar
manner.
<Fig. 1>
Step 1
1 mm 3 stitches
Step 2
1.5 mm 4 stitches
Step 3
1 mm 3 stitches
Step5
1.5 mm 2 stitches
Step 4
‒1 mm 3 stitches
Condensation custom No. 1
8-5-2. Creating a new condensation custom
①
Selecting the condensation custom pattern setting on the mode screen
1. Press
❶
.
The "mode screen" is displayed.
2. Select the "4. Condensation custom sewing
setting".
The "condensation custom pattern list
screen" is displayed.
❶
<Mode screen>
Create the new condensation custom No. 1 shown in <Fig. 1> as an example.
1. Desired stitches may not be formed
depending on the sewing speed. If desired
stitches are not produced, the sewing speed
should be reduced.
2. In the case the pitch is 0.00 mm, it is not
possible for the needle to enter the same
needle entry point.
To Next Page
Loading...
Need help?
General
