19
Bobbin thread preparation
Open the hook cover.
Take out the bobbin.
* If the bobbin has too little thread, do not use it as the
thread will get tangled.
* Use only the designated bobbin. Other bobbins may
cause malfunction.
1
2
Taking out the bobbin
1
Small spool
Large spool
Spool Cap
Place a thread spool to spool pin and a
spool cap onto the spool pin.
* Be aware that a spool with a small remaining
amount of thread can cause tangling or slip-off of
thread.
There are three types of the spool caps, large, medi-
um and small. Choose the size of spool cap according
to the thread spool to be used.
Setting thread spool
Hook cover
Spool Cap
<Exclusive bobbin>
Made of transparent plastic
11.5 mm
20.5 mm
When the bobbin is taken
out and/or put into the bob
-
bin case, turn off the power
(turn to “O”).
Attention
To Next Page
Loading...
Need help?
General
